How to create a 3D jewellery set
What you need:
Results – These can be various based on own preferences:
Applications:
Guidelines:
- Initially you will have to have to noticed/file the sprue off the elements
- You can pre buff/ pre polish the star parts which makes cleansing a lot easier immediately after soldering
- Employing buff sticks to buff back again the cast finish going from coarse to wonderful
- At the time you have acquired to fine buff paper you can begin to polish using luxi compound –blue for initially stage with the calico mop
- There are guideline marks on the place of the star pendant and earrings you want to solder jump rings to
- You can file bounce rings with triangular file to give them an angle at the finishes so they sit flat from the stage of the star
- Use solder paste where the guideline marks are on the stars
- On the soldering block, push the jump ring against the stars guide marks and use tweezers to hold the leap ring in area
- Using the hand torch, warmth up the solid star and as soon as it is starting to transform color bit by bit go together to the bounce ring so it will get to tempreture at similar time until eventually the solder melts and joins the parts with each other
- Quench and put it in pickle, rinse soon after pickling to clean off acids.
- If you didn’t buff and pre polish previously now you will have to have to buff again the forged finish and if you need to eliminate any added solder
- Polish the piece employing luxi compound – blue for to start with phase working with a calico mop
- Then polish with White luxi compound and a fluffy mop
- For your earrings you can open up up your ear wire and then shut it back again together
- For the star pendant necklace, dependent on the bail you select you can possibly insert it immediately the the soar ring or if needed you could need to incorporate yet another lesser soar ring before the bail.
- Ultrasonic or clean off any residual polish and insert a chain to the pendant.
Optional: you can possibly fully shut your conclusions by soldering them during soldering action 9 or depart the results semi open and just pushed together .
